Resetting Handsets; Registering Handsets - Uniden DECT 1730 Series Owner's Manual

Installing a Line Filter or DSL Filter
A telephone line filter or DSL filter prevents services that use the phone
line from causing interference on your phone. To get a line filter, contact
your service provider or look in an electronics store.
Plug the filter into the telephone wall jack and plug the base into the filter.
Make a test call to make sure the noise is gone.
Liquid Damage
CAUTION: If the base is covered in liquid, disconnect the adaptor
and phone cord from the wall before touching it.
If the liquid is only on the exterior housing of the base or handset, wipe it
off and use as normal. If you can hear liquid inside the housing:
1. Remove all compartment covers, and disconnect all cables and cords.
2. If liquid is leaking from any vent or hole, turn the phone so that vent
faces down. If not, place the largest vent face down.
3. Let dry for at least 3 days. Check for liquid inside the phone before
replacing compartment covers and reconnecting cords.

Resetting Handsets

If you have trouble with a handset or if you want to replace one, clear the
registration information from the base and the handset:
1. Press & hold END and # at the same time until you see the System
Reset menu.
2. If you still have the base the handset is registered to, select Deregister
HS, then select the handset you want to reset. If you don't have that
base anymore, select Base Unavailable.
3. To confirm, select Yes. The handset displays Handset not registered.

Registering Handsets

If you see a "not registered" message on a handset, you must register it
to a base before using it.
1. On the base, press and hold FIND HS for about 7 seconds and then
release.
2. On the handset, press and hold hash (#) key until the display shows,
Handset Registering (about 2 seconds).
3. If you don't hear a dial tone or the display says "Registration Failed",
charge the battery completely, then try again.
26