Table of Contents
Advertisement
Internet radio/ DAB/ FM
• When the alarm activates, press [volume -/+]/ [
stop the alarm.
• Repeatedly press [SNOOZE] or [SNOOZE] on the remote
control to activate snooze mode.
• The alarm turns off for the selected time interval
(5/10/15/30/60 minutes) before activating once again.
• Repeatedly press [SNOOZE] or [SNOOZE] on the remote
control to activate ON instead of snooze mode. The radio
now stays switched on.
• If the alarm is not stopped, the radio automatically
switches into standby mode after one hour.
15. System settings
You can modify all settings and access important
information about the radio in the System settings.
15.1 Equaliser
The equaliser allows you to adjust the sound of the radio to
suit your preferences by amplifying or reducing the amount
of bass or treble in the audio .
You can choose from preconfigured profiles, adjusted to suit
a variety of music genres, or create your own custom profile.
• To set the Equaliser, proceed as follows:
] to
[menu]
System settings
Equaliser
30
• Use [enter/navigate] to choose one of the
preconfigured profiles.
• To create your own equaliser profile, choose the option
My EQ profile setup.
• This takes you to the settings for Bass, Treble and
Loudness (volume amplification).
• To adjust a particular value, press [enter/navigate]
at the corresponding menu item and then change the
value by turning [enter/navigate]. If playback is already
started when you modify these settings, you can hear the
changes in the audio immediately.
• Confirm your settings by pressing [enter/navigate] once
more.
• Complete the configuration process by pressing [back]
on the device and confirm the saving of settings by
pressing [enter/navigate].
• To use the new profile, choose the item My EQ.
15.2 Network
15.2.1 Network wizard – Configuration of internet
connection / Automatic search
The Network wizard supports you to set up a
connection between the radio and internet. Hereby you
can choose between a wired LAN connection and a
wireless connection using WLAN/Wi-Fi. More methods
of configuration and detailed information are amplified
subsequently.
• You can start the Network wizard as follows:
• When the wizard is started, the radio searches for WLAN
(WiFi) connections and then shows a list of the available
networks.
• Turn [enter/navigate] to switch amongst the networks
discovered. At the bottom of the list are options to
restart the search ([Rescan]), select a cable connection
([Wired]) or configure the connection yourself ([Manual
config]).
• If your network is not found or the SSID (Service Set
Identification, that is, the name of your network) is not
shown, the network may be hidden or out of range. In
this case, try manual configuration or connecting by LAN
cable.
[menu]
System settings
Network
Network wizard
Advertisement
Table of Contents
