Canceling The Registration Of The Adapter - Sharp HN-VA100U Operation Manual

Canceling the Registration of the Adapter

Canceling the Registration of the Adapter
To cancel the network registration of the adapter, follow the steps below.
This should be done in the following situations:
♦
You attempted to register the adapter, but registration failed.
♦
You wish to change the registration of the adapter to a different network.
♦
You are going to discard or give the adapter to someone else, or have
the adapter serviced.
♦
If you suspect that someone is using an adapter to gain unauthorized
access to your network, cancel the registration of all adapters on your
network and then re-register the adapters.
Note: Perform the following steps with the adapter plugged into an
electrical outlet.
1
On the adapter whose registration you want to cancel, hold down the SET
button on the adapter until the POWER indicator turns off (about 10
seconds) and then release the button.
2
Wait until the POWER indicator turns back on. Registration cancellation is
now complete.
• Important: Do not remove the adapter from the outlet until the POWER
indicator turns on, as cancellation may not be complete. (It may take as
long as 30 seconds for cancellation to be completed.)
• To use the adapter again, you will need to register it as explained on page
8.
18
SET