Miscellaneous Problems - Canon imageCLASS MF3010VP User Manual

Miscellaneous Problems

See the following sections.
Steam is emitted from the machine's output area.(P. 173)
Water droplets form on the back side of the operation panel and in the output area.(P. 173)
The settings that you specified are not enabled or saved.(P. 173)
Steam is emitted from the machine's output area.
Use only in the machine. Moisture evaporates from damp paper due to the heat generated inside the
fixing unit (it is most likely to occur at low room temperatures). This is not a malfunction, but you can
prevent this by using a stack of new unopened paper.
Should you smell something burning, immediately turn OFF the machine, unplug the power plug from
the AC power outlet, and contact your local authorized Canon dealer or the Canon help line. Continued
use may lead to a fire or electrical shock.
Water droplets form on the back side of the operation panel and in the
output area.
Use only in the machine. Moisture evaporates from damp paper due to the heat generated inside the
fixing unit (it is most likely to occur at low room temperatures). This is not a malfunction, but you can
prevent this by using a stack of new unopened paper.
Should you smell something burning, immediately turn off the machine, unplug the power plug from the
AC power outlet, and contact your local authorized Canon dealer or the Canon help line. Continued use
may lead to a fire or electrical shock.
The settings that you specified are not enabled or saved.
If the machine is turned OFF immediately after changes have been made to the settings from the
operation panel, the changes may not be saved on the machine.
Wait for approximately five seconds after changes have been made to the settings and turn OFF the
machine.
Troubleshooting
173
85RS-042