Table of Contents
Advertisement
MAINTENANCE AND STORAGE
Overview of cleaning
1.
Clean the machine. Wipe the unit with a slightly damp cloth. Do not clean the machine
using a high-pressure water jet.
2.
Clean the high-pressure nozzle with needle. (Fig. O)
The pressure washer is equipped with a water filter to protect the pump. If the filter is not kept
clean, the water flow to the machine will be restricted and the pump may be damaged.
1.
To clean water filter, remove transfer adapter and take out filter.
2.
Rinse filter until it is free of debris and blockages.
3.
Replace the filter and inlet adapter.
Storing
Store the machine in a dry and well ventilated area.
When the machine is not going to be used for an extended period of time, ensure to remove
the cleaning agent and drain all remaining water from the hose.
Transport
Daily use
- Pull out the transport handle until it audibly snaps into place. Pull the appliance by its
transport handle. (FIG.P)
If shipping, use the original packaging wherever possible.
Disposing of the machine
This machine must not be disposed of in household rubbish. You must dispose of such old
electrical and electronic appliances separately.
Please check with your local authority how to correctly dispose of your old machine.
Disposing of the packaging
The packaging consists of cardboard and correspondingly marked sheets that should be
recycled. Ensure to recycle this packaging in line with local recycling guidelines.
24
TROUBLESHOOTING
WARNING: Before performing any repair work, always ensure that the mains power
cable has been unplugged.
WARNING: Always wear heavy duty gloves when adjusting or cleaning, especially
when handling sharp objects.
Symptom
Cause
ON/OFF switch is in the "OFF"
Motor does
(O) position.
not run when
Power cord is not plugged in.
"ON" ( I ), fully
Electrical outlet does not
connected
supply adequate power.
and trigger
depressed.
Tripped pressure washer
thermal protector.
Water supply is restricted.
Not enough water supply.
Water inlet filter is clogged.
Nozzle is in low pressure
Unit does not
reach high
pressure.
Pump is sucking air.
Not enough inlet water supply.
Pump is sucking air.
Output
pressure varies
Water inlet filter is clogged.
ON/OFF switch
is in the "OFF"
Discharge nozzle is obstructed.
(O) position.
Calcified gun, hose or power
nozzle.
Solution
Turn switch to the "ON" (I) position.
Plug in power cord.
Try a different outlet.
Allow to cool and restart unit.
Check garden hose for kinks, leaks and
blockage.
Open water source fully.
Remove filter and rinse in warm water.
Adjust the nozzle to high pressure position.
Check that hoses and fittings are airtight.
Turn OFF machine and purge pump by
squeezing trigger gun until a steady flow of
water emerges through the nozzle.
Turn water on fully. Check garden hose for
kinks, leaks or blockage.
Check that hoses and fittings are airtight.
Turn OFF machine and purge pump by
squeezing trigger gun until a steady flow of
water emerges through the nozzle
Remove filter and rinse with warm water.
Blow out or remove debris with a fine
needle.
Run distilled vinegar through detergent
tank.
25
Advertisement
Table of Contents
