Adding Z-Wave Devices; Z-Wave Device Drivers - Control 4 Z-Wave C4-ZWDUSB Setup Manual

Adding Z-Wave devices

Z-Wave device drivers

• Send Node Info—When connected to another mesh, Send Node Info sends
information about the controller to all other devices on the mesh.
After configuring your Z-Wave controller, add drivers corresponding to the
Z-Wave devices to your project. Many Z-Wave device drivers will also need a
motorization, sensor, or light driver, like a door or window driver, added into
your Control4 project to represent the Z-Wave device in a Control4 Navigator.
To add a Z-Wave device driver into your project:
1 In System Design, enter the name of driver in the Search tab.
2 Double-click on the driver to add it into the project. You can also right-click
on the driver and select Add to Project to add the driver.
3 If you have more than a couple Z-Wave devices, it is recommended that
you rename this driver to help with troubleshooting multiple devices. Right-
click on the driver and select Rename. Enter a descriptive name and press
Enter.
Most Z-Wave device drivers will also need a motorization, sensor, or light driver.
For example, a window contact sensor device driver also needs the Window
Contact Sensor driver and an outlet module device driver needs the Z-Wave
Dimmable Light (Outlet) driver.
5