Table of Contents
Advertisement
3.2 Setup Flow
You have to set up your printer to use it. And you can adjust some features by customizing them. This
section describes the setup.
The set up flow of preparing to use printer is below.
3. Connect the Printer to the host PC/POS terminal
When you select Direct
control method (ESC/
POS command,) you
don't need to install any
drivers.
Note:
When you use OPOS (OCX driver from EPSON) or the Advanced Printer Driver, you need to install the driver.
When you use ESC/POS commands, you don't have to install drivers. For information on these drivers, see
"Control Method" on page 2-1 and "Install a Printer Driver in the Host PC / POS Terminal" (page 3-23).
3-3 Setup
1. Printer set up
❏Install Ribbon Cassette
❏Install Paper Roll
❏ Connect the Printer to the Power Supply
(See "Printer setup," page 3-5)
(See "Install a Printer Driver in the Host PC / POS Terminal" (page 3-23))
2. Adjust various settings (If you need to)
❏ Memory switches
❏ Paper width
(Adjust the spacer & Memory switches)
❏ Roll Paper Near End Detector
(For equipped model only)
(See "Adjusting Various Settings" (page 3-14))
4. Driver setup
❏OPOS
❏ APD
(See "Install a Printer Driver in the Host PC / POS
Terminal," page 3-23)
5. Complete set up
Advertisement
Table of Contents
