Table of Contents
Advertisement
Vibration resistance:
Impact resistance:
1.6.3 Installation
Install the printer horizontally as a basic position.The printer also must be installed so that it does not
move or vibrate during paper cutting or the drawer kick operation. Affixing tape is available as an option.
1-12 General Information
When packed:
Frequency: 5 to 55 Hz
2
Acceleration: 19.6m/s
Sweep: 10 minutes (half cycle)
Duration: 1 hour
Directions: x, y, and z
No external or internal damage should be found after the vibration test, and
the unit should operate normally.
When packed:
Package: EPSON standard package
Height: 60 cm (2 feet)
Directions: 1 corner, 3 edges, and 6 surfaces
No external or internal damage should be found after the drop test, and the
unit should operate normally.
When unpacked:
Height: 5 cm (2")
Directions: Lift one edge and release it (for all 4 edges).
When the printer is not printing, no external or internal damage should be
found after the drop test.
{2 G}
Advertisement
Table of Contents
