Programming A Non-Rolling Code - Dodge Challenger SRT Includes 392/Hellcat 2016 Owner's Manual

204 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Firmly push and release the "LEARN" or "TRAIN-
ING" button. On some garage door openers/devices
there may be a light that blinks when the garage door
opener/device is in the LEARN/TRAIN mode.
NOTE: You have 30 seconds in which to initiate the next
step after the LEARN button has been pushed.
6. Return to the vehicle and push the programmed
HomeLink button twice (holding the button for two
seconds each time). If the garage door opener/device
activates, programming is complete.
NOTE: If the garage door opener/device does not acti-
vate, push the button a third time (for two seconds) to
complete the training.
To program the remaining two HomeLink buttons, repeat
each step for each remaining button. DO NOT erase the
channels.
Reprogramming A Single HomeLink Button
(Rolling Code)
To reprogram a channel that has been previously trained,
follow these steps:
1. Cycle the ignition to the ON/RUN position.
2. Push and hold the desired HomeLink button until the
indicator light begins to flash after 20 seconds. Do not
release the button.
3. Without releasing the button, proceed with "Pro-
gramming A Rolling Code" step 2 and follow all
remaining steps.

Programming A Non-Rolling Code

For programming Garage Door Openers manufactured
before 1995:
1. Place the ignition in the ON/RUN position.