Programming A Rolling Code; Programming A Non-Rolling Code - Dodge GRAND CARAVAN 2019 User Manual

Programming A Rolling Code

For programming garage door openers that were
manufactured after 1995:
These garage door openers can be identified by the
"LEARN" or "TRAIN" button located where the
hanging antenna is attached to the garage door
opener. It is NOT the button that is normally used
to open and close the door. The name and color of
the button may vary by manufacturer.
1. Place the ignition in the ON/RUN position.
2. Place the hand-held transmitter 1 to
3 inches (3 to 8 cm) away from the
HomeLink button you wish to program while
keeping the HomeLink indicator light in
view.
3. Push and hold the HomeLink button you
want to program while you push and hold the
hand-held transmitter button.
4. Continue to hold both buttons and observe
the indicator light. The HomeLink indicator
will flash slowly and then rapidly after
HomeLink has received the frequency signal
from the hand-held transmitter. Release
both buttons after the indicator light
changes from slow to rapid.
5. At the garage door opener motor (in the
garage), locate the "LEARN" or "TRAIN-
ING" button. This can usually be found
where the hanging antenna wire is attached
to the garage door opener/device motor.
Firmly push and release the "LEARN" or
"TRAINING" button. On some garage door
openers/devices there may be a light that
blinks when the garage door opener/device is
in the LEARN/TRAIN mode.
NOTE:
You have 30 seconds in which to initiate the
next step after the LEARN button has been
pushed.
6. Return to the vehicle and push the pro-
grammed HomeLink button twice (holding
the button for two seconds each time). If the
garage door opener/device activates, pro-
gramming is complete.
NOTE:
If the garage door opener/device does not
activate, push the button a third time (for
two seconds) to complete the training.
To program the remaining two HomeLink
buttons, repeat each step for each remain-
ing button. DO NOT erase the channels.
Reprogramming A Single HomeLink Button
(Rolling Code)
To reprogram a channel that has been previously
trained, follow these steps:
1. Cycle the ignition to the ON/RUN position.
2. Push and hold the desired HomeLink button
until the indicator light begins to flash after
20 seconds. Do not release the button.
3. Without releasing the button, proceed with
"Programming A Rolling Code" step two and
follow all remaining steps.

Programming A Non-Rolling Code

For programming Garage Door Openers manu-
factured before 1995:
1. Place the ignition in the ON/RUN position.
NOTE:
For vehicles equipped with Keyless Enter-N-
Go, place the ignition in the RUN position
with the engine ON. Make sure while pro-
gramming HomeLink with the engine ON
that your vehicle is outside of your garage, or
that the garage door remains open at all
times.
41