Service The Parksense Rear Park Assist System; Cleaning The Parksense System - Dodge Challenger SRT Includes 392/Hellcat 2016 Owner's Manual

Service The ParkSense Rear Park Assist System

During vehicle start up, when the ParkSense Rear Park
Assist System has detected a faulted condition, the
instrument cluster will actuate a single chime, once per
ignition cycle and it will display the "PARKSENSE
UNAVAILABLE WIPE
"PARKSENSE UNAVAILABLE SERVICE REQUIRED"
message for five seconds. Refer to "Driver Information
Display (DID)" in "Understanding Your Instrument
Panel" for further information.
When the gear selector is moved to REVERSE and the
system has detected a faulted condition, the Driver
Information Display
"PARKSENSE UNAVAILABLE WIPE REAR SENSORS"
or "PARKSENSE UNAVAILABLE SERVICE REQUIRED"
message for as long as the vehicle is in REVERSE. Under
this condition, ParkSense will not operate.
REAR SENSORS"
(DID) will display
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 195
If "PARKSENSE UNAVAILABLE WIPE REAR SEN-
SORS" appears in the Driver Information Display (DID),
make sure the outer surface and the inside of the rear
fascia/bumper is clean and clear of snow, ice, mud, dirt
or other obstruction, and then cycle the ignition. If the
message continues to appear see an authorized dealer.
or
If "PARKSENSE UNAVAILABLE SERVICE REQUIRED"
appears in the DID, see an authorized dealer.

Cleaning The ParkSense System

Clean the ParkSense sensors with water, car wash soap
and a soft cloth. Do not use rough or hard cloths. Do not
scratch or poke the sensors. Otherwise, you could dam-
the
age the sensors.
3