Dodge Challenger SRT Includes 392/Hellcat 2016 Owner's Manual page 291

When "Lights & Chime" mode is activated, the Blind
Spot Monitor (BSM) will show a visual alert in the
exterior mirrors as well as an audible alert when the turn
signal is on. When "Off" is selected, the Blind Spot
Monitor (BSM) system is deactivated. To change the
Blind Spot Alert status, press the "Off," "Lights" or
"Lights & Chime" button on the touchscreen.
NOTE: If your vehicle has experienced any damage in
the area where the sensor is located, even if the fascia is
not damaged, the sensor may have become misaligned.
Take your vehicle to an authorized dealer to verify sensor
alignment. Having a sensor that is misaligned will result
in the BSM not operating to specification.
• ParkView Backup Camera Active Guidelines
Your vehicle may be equipped with the ParkView Rear
Back Up Camera Active Guidelines that allows you to see
active guidelines over the ParkView Back up camera
display whenever the gear selector is put into REVERSE.
UNDERSTANDING YOUR INSTRUMENT PANEL 289
The image will be displayed on the radio touchscreen
display along with a caution note to "check entire sur-
roundings" across the top of the screen. After five sec-
onds, this note will disappear. To make your selection,
press the "ParkView Backup Camera Active Guidelines"
button on the touchscreen, until a check-mark appears
next to setting, indicating that the setting had been
selected.
• ParkView Backup Camera Delay
When the vehicle is shifted out of REVERSE (with camera
delay turned OFF), the rear camera mode is exited and
the navigation or audio screen appears again. When the
vehicle is shifted out of REVERSE (with camera delay
turned ON), the rear view image with dynamic grid lines
will be displayed for up to 10 seconds after shifting out of
"REVERSE" unless the forward vehicle speed exceeds
8 mph (12 km/h), the transmission is shifted into
"PARK" or the ignition is switched to the OFF position.
4