Table of Contents
Advertisement
4.3 Installing an SD Card
1. Remove protective cover from the SD Card slot.
2. Insert the SD Card into the rear of the camera.
3. Replace the protective cover.
4.4 Installing Cables to I/O Ports
1. Use a small flathead screwdriver to press the switch above the applicable I/O port.
2. Insert the exposed end of the cable into the I/O port. Note: It is recommended to route cables
through a metal conduit for outdoor applications.
3. Remove the screwdriver to close the port.
Figure 4-2
Figure 4-3
11
Advertisement
Table of Contents
