Table of Contents
Advertisement
Setting the built-in clock date and
time
This unit records file creation dates and times using its internal
clock.
In addition, built-in clock date and time data is also used for
recording file names as well as for file names when saving
various library data and All System Data, for example.
For these reasons, we recommend setting the date and time
accurately.
1.
Tap Menu Screen > System Setup > Clock Adjust to open
the CLOCK ADJUST Screen.
2.
Tap the EDIT button to enable setting mode for this screen.
3.
Swipe up and down to change values.
4.
Tap the APPLY button to complete setting the date and
time of the built-in clock.
NOTE
Tap the CANCEL button to exit setting mode.
Connecting and disconnecting SD
cards and USB flash drives
SD cards and USB flash drives can be connected and
disconnected whether the unit is on or off.
ATTENTION
Never disconnect an SD card or USB flash drive when it is
being accessed, such as in the cases listed below.
Doing so could cause proper recording to fail, data to be
lost, and sudden loud noises from monitoring equipment,
which might damage the equipment, harm hearing or cause
other trouble. Moreover, disconnecting during a firmware
update could result in the unit becoming unable to start up
or operate properly.
i Recording (SD cards only)
i Playing back
i During IMPORT/EXPORT of snapshot data
i During BACKUP/RESTORE of All System Data
i During firmware updates (See "Firmware update
procedures" on page 217.)
i When an SD card or USB flash drive is being accessed with
the BROWSE screen
NOTE
i Insert an SD card into the SD card slot on the top of the unit
so that its label faces right.
i To remove an SD card, press it in gently to make it to come
out and then pull it out completely.
SD card write protection switches
SD cards have write-protection switches that prevent writing
new data to them.
If you slide the write-protection switch to the "LOCK" position,
writing will not be possible. Move the write-protection switch
to the unlocked position in order to record, erase and otherwise
edit data on the card.
This unit also writes settings data for recording/playback folders
on these media. Since setting information cannot be written
to write-protected SD cards, settings for recording/playback
folders will not be retained when the unit is restarted and
performance will be otherwise affected.
Preparing SD cards and USB flash
drives for use
Always use this unit to format the SD cards and USB flash drives
to be used with it. (See "Media Manage Screen" on page 216.)
Operation of this unit might be affected when using an SD card
or USB flash drive that has been formatted by a computer or
other device.
ATTENTION
i Formatting erases all the data on the SD card or USB flash
drive.
i SD cards formatted by this unit are optimized to improve
performance during recording. Use this unit to format the SD
cards to be used with it. Errors might occur when recording
with this unit using an SD card formatted by a computer or
other device.
TASCAM Sonicview 16XP/Sonicview 24XP V1.5.0
3 - Preparation
33
Advertisement
Table of Contents
