Reset; Adjust; Mode Set; Dmx-Controlled Operation - EuroLite LED TMH FE-1800 User Manual

Select temperature designation
With this function you can select the temperature designation.
• Select "Temp C/F" by pressing Up or Down.
• Press Up or Down to select the desired degree between "Celsius" and "Fahrenheit".
• Press the Enter-button to confirm.
Reload Default
With this function you can restore the factory settings of the device. The different settings (marked in the
table) will be set back to the default values (shaded).

Reset

With this function you can reset the device via the Control Board.

Adjust

Calibration (Calit CH)
With this function, you can calibrate PAN, TILT and the rotating lens to their correct starting positions. The
password for this function is „050".

Mode set

With this function you can set the DMX channel mode via the Control Board.

DMX-controlled operation

You can control the projectors individually via your DMX-controller.
The device has two different DMX channel modes.
Every DMX-channel has a different occupation with different features. The individual channels and their
features are listed under DMX-protocol.

Addressing

he Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the LED TMH FE-1800 will respond to the controller.
If you set, for example, the address in the 40 channel mode to channel 41, the device will use the channel 41
to 80 for control.
Please, be sure that you don't have any overlapping channels in order to control each LED TMH FE-1800
correctly and independently from any other fixture on the DMX-chain.
If several LED TMH FE-1800 are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the LED
TMH FE-1800 via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If there is
no data received at the DMX-input, the display will flash.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
32/38 00094080.DOC, Version 1.0