Mount your camera
Drill the screw holes and the cable hole if necessary with the drill template
comes with the package.
Fix the mounting base on the ceiling or the wall with the screws that come
with the package. Route the cables to the cable hole.
Loosen the lock ring and then adjust the camera position. Tighten the lock
ring when you setup the camera position.
Loosen No.1 lock screw to adjust the tilt angle [0 ° to 100°].
Loosen No.2 lock screw to adjust the pan angle [0° to 360°].
Loosen No.3 lock screw to rotate the camera [0° to 360°].
Tighten the lock screws.