Siemens SIMOTICS 1LE8 Operating Instructions Manual page 157

Danger when incorrectly lifting and transporting
Danger of death, serious injury, or substantial material damage caused by tipping or falling
transported goods. Comply with the following safety instructions:
• All work must be performed with due caution and care.
• Comply with any notes in the shipping papers.
• Carefully comply with all of the handling information and markings on the packages
• Only use suitable and adequately dimensioned lifting equipment, transport equipment
Danger due to incorrect attachment and lifting
• Ensure that suitable lifting equipment is available.
• Only hoist the goods using the designated hoisting points and/or at marked positions. The
• Use suitable strap guiding or spreading devices.
• If not specified otherwise in the transport data, always transport the motor in the position
Danger due to damaged attachment points
• Carefully check the attachment points provided on the motor, e.g. attachment eyes, lifting
• Before using, carefully ensure that the attachment points are correctly attached.
Danger when incorrectly transporting the motor suspended from cables or ropes
If you transport the motor suspended from cables or ropes, the cables or ropes can break, e.g.
as a result of damage. Further, if not adequately attached, the motor can swing. This can
result in death, serious injury, or material damage.
• Use additional, suitable lifting equipment for transport and during installation.
• Two cables alone must be able to carry the complete load.
• Prevent the lifting equipment from sliding by appropriately securing it.
• When using 2-cable lifting equipment, ensure that the maximum angle of inclination is ≤
• Align the eyebolts so that the cables used for lifting are aligned with the planes of the
1LE8 轴高 80 ... 355
操作说明, 11/2022, A5E52373573A
whenever transporting and putting the equipment into storage according to ISO 780.
and industrial trucks.
attachment points are not dimensioned for additional loads.
associated with its specific type of construction.
lugs or ring bolts for possible damage. Replace any damaged attachment points.
45° according to ISO 3266 (DIN 580).
eyebolts.
Preparing for use
4.5 Transport and storage
155