Status; Intercom; Voice Mail; Call Features - Yealink Horizon W52P Full User Manual

Status

You can view the system status of the base station and the handset. Below is the available
information:

Base Station Status: Information about the IP Address, Mac address, Firmware
version and network settings will be included

Handset Status: Information for the hardware version, model, IPUI code and firmware
version of the handset can be found

Line Status: You can check the status of the line

Intercom

Using this feature you can make internal calls to the other handsets that are registered under the
same base station.

Voice Mail


Play Message: You can access your voice mail system

Set Voice Mail: It is not recommended to make any changes on the voice mail
settings

Set Key 1: By default if you press the key 1 you will call to the voice mail

Call Features


Call Forwarding: There are 3 call forwarding types

Always Forward: Incoming calls are immediately forwarded.

Busy Forward: Incoming calls are immediately forwarded if the line is busy.

No Answer Forward: Incoming calls are forwarded if not answered after a period of
time.

Do not Disturb: If the DND is enabled all the incoming calls will be rejected

Directory

You can configure up to 500 local contacts. All the contacts will be saved on the base station.
Currently only the local directory is available. Note: LDAP-Corporate directory search is not
available on this particular device.
Horizon | Yealink W52P Full User Guide
© Gamma 2016. All rights reserved. Confidential.
Page 11 of 27