9-Installation - Haier HW150-BP14986ES9 User Manual

EN
9.1 Preparation
Take the appliance out of the packaging.
Remove all packaging material including polystyrene base, keep them out of childrens
reach. While opening the package, water drops may be seen on plastic bag and port-
hole. This normal phenomenon results from water tests in the factory.
Note: Packaging disposal
Keep all packaging materials out of children´s reach and dispose them in an environ-
mentally friendly manner.
9-1
noise redu-
9-3
2x
,
1x
1x
Note: Noise reduction pad
Noise reduction pad is optional , could help to reduce noise , please assemble it or not
according to your own demand. .
9-4
9-6
E
./0 1
9-2
./0 2
1/ .4
9-5
.
A
B
9-7
C
F
D
9.2 Install metal board
1. Tilt back the appliance (Fig. 9-1).
2. Get the metal board from the top of the
packaging foam and install to the bottom of the
appliance, then fi x the metal board with four
screws (Fig. 9-2).
3. Take out the noise reduction pads and remove
the double-sided adhesive protective film; place
the noise reduction pads under the washing ma-
chine cabinet as shown in Figure 9-3(two longer
pads in position 1 and 3, two shorter pads in
position 2 and 4). Finally set the machine upright
again.
9.3 Dismantle the transportation bolts
The transportation bolts are designed for clamping
anti-vibration components inside the appliance during
transportation to prevent inner damage.
1.
Remove the 4 transportation bolts (A) on the rear
side and take out plastic spacers (B) from inner
side of the machine (Fig. 9-4 and 9 -5).
2. Remove the strengthen pieces screws (C), then
re-move the strengthen pieces (D) and take out
pack-ing rods (E) innerside of the appliance (Fig.
9-6).
3. Fill left holes with blanking plugs (F) (Fig. 9-7).

9-Installation

27