Table of Contents
Advertisement
9.1 Preparation
Take the appliance out of the packaging.
Remove all packing material including polystyrene base, keep them out of childr-
ens reach. While opening the package, water drops may be seen on plastic bag
and porthole. That nomal phenomenon results from water tests in the factory.
Note: Packaging disposal
Keep all packaging materials out of children´s reach and dispose them in an environm-
entally friendly manner.
9.2 OPTIONAL: Adjusting the bottom cover board
When opening the package, you will find a bottom
cover (A) .The board is used for reducing noise after
covering the bottom of the cabinet.
1. Lay the washing machine down to its side, windo-
ws upwards, Bottom side towards operator.
2. Insert the Bottom plate into the cabinet, Then fixed
with 2 screws to the cabinet on the window side.
Finally set the machine upright again (Fig. 9-2).
9.3 Dismantle the transportation bolts
The transportation bolts are designed for clamping
anti-vibration components inside the appliance du-
ring transportation to prevent inner damage.
1. Remove the back cover.
2. Fill the 5 holes with blank-
ing plugs (Fig. 9-3).
9-Installation
1.
On the top of the package
1
3
4
5
2
Remove the four
packing bolts
2.
3.
Tighten with
two screws
(
)
Packing bolt
1234
(
Hole wall
12345
Plug the five hole walls
9-2
Front
Back
9-3
)
24
Advertisement
Table of Contents
