Connecting To A Dvd Player And Dtv Decoder - Sharp DT-200 Operation Manual

Connecting to Video Equipment
Projector
1
1

Connecting to a DVD Player and DTV Decoder

Connecting to a DVD player and DTV decorder with Component output (for INPUT 1)
Projector
1
Connecting to a DVD player and DTV decoder with component output (for INPUT 2)
1 Connect the 3 RCA to 15-pin D-Sub cable using the DVI to 15-pin D-Sub adaptor.
2 Use the above cables to connect the projector and the DTV decoder.
When connecting this projector to analog RGB output of the DTV decoder, select "Component" for "Signal Type" on the
OSD menu or press RGB/COMP. on the remote control. (See page 36.)
CAUTION
• Make sure to turn both the projector and the video equipment off, before switching the "DIGITAL INPUT TYPE" swich and
connecting.
DVI to 15-pin D-sub adaptor
(sold separately AN-A1DV)
E-13
DT-200(E)#p12_14.p65
S-video cable (commercially available)
2 To S-video output terminal
Video cable
2 To video output terminal
1 Connect each RCA connector of a component cable to the corresponding
RCA INPUT 1 terminals on the projector.
2 Connect the other end of the cable to the corresponding terminals on a DVD
player or DTV decoder.
CAUTION
• Make sure to turn both the projector and the video equipment off, before switching
the "DIGITAL INPUT TYPE" swich and connecting.
Component cable
(commercially available)
Projector
3 RCA to 15-pin D-sub cable
(sold separately AN-C3CP)
13
VCR, Laser disc player,
DVD player or DTV decoder
2 To component output
terminals
DVD player
or
DTV decoder
02.11.21, 11:30 AM
DVD player
or
DTV decoder