Data Loading - Sharp ER-A247 Instruction Manual

■ Data loading
The programming data can be loaded from the SD card.
Procedure
(1) Select "2 LOADING" in the SD CARD mode and press the
is displayed.
Item
IND. PROGRAM
ALL PROGRAM
ALL RAM DATA*
(2) Select the data menu from the list and press the
To load the programming data file, select OK and press the
To cancel the operation, select CANCEL and press the
* When "ALL RAM DATA" is selected, the register resets the program in the last save point after loading all
the RAM data.
The loading operation must be circumspect in execution, the sales data and/or all programming
NOTE
data will be recovered with the back-up data.
Error message table of the SD card function
Error message (display)
CARD FULL
CARD PROTECT
FILE FAILED
NO CARD
NO FILE
NO FOLDER
OVER LIMIT.
SD ACC POWER OFF
SD ERROR
Select the individual programming data:
DEPARTMENT
PLU
CLERK
GRAPHIC LOGO
LOGO TEXT
TAX
All programming data
All RAM data
The SD memory card is full. Delete unnecessary data from the card on a PC or
replace the card with a new one. When using a new SD memory card, be sure
to format it in advance.
The write-protect switch on the SD memory card is in the "PROTECTED"
position. Set the switch on the "NOT PROTECTED" position.
The data stored in the SD memory card is incorrect. Write correct data into the
SD memory card on a PC.
No SD memory card is found. Insert an SD memory card into the SD card slot
or reinsert it correctly.
The designated file is not found.
The user folder is not found. (SHARP/ECRER2X7/user folder name)
The maximum allowable number of times of sales data writing is exceeded.
Delete unnecessary data from the SD memory card on a PC or replace the
card with a new one. When using a new SD memory card, be sure to format it
in advance.
A power failure has occurred while the SD memory card is accessed. Perform
the interrupted operation again from the beginning after power recovery.
An error other than the above mentioned has occurred while the SD memory
card is accessed. Perform the interrupted operation again from the beginning.
A key. The following selection window
Data list
A key, the confirmation window is displayed.
A key.
A key.
Error status and action
95