Table of Contents
Advertisement
3 Follow the below procedures in order to drain water.
If the product has an emergency water draining hose, in order to drain the water:
If the product does not have an emergency water drain hose, in order to drain
the water:
4 Clean any residues inside the filter as well as fibers, if any, around the pump impeller
region.
5. Replace the filter.
6. If the filter cap is composed of two pieces, close the filter cap by pressing on the tab. If
it is one piece, seat the tabs in the lower part into their places first, and then press the
upper part to close.
39 / EN
a
Pull the emergency draining hose out
from its seat
b
Place a large container at the end of
the hose. Drain the water into the
container by pulling out the plug at the
end of the hose. When the container
is full, block the inlet of the hose by
replacing the plug. After the container
is emptied, repeat the above procedure
to drain the water in the product
completely.
c
When draining of water is finished,
close the end by the plug again and fix
the hose in its place.
d
Turn and remove the pump filter.
a. In order to collect the water to flow out
of the filter, place a large vessel in front
of the filter.
b. Turn and loosen the pump
filter until water starts to flow
(counterclockwise). Fill the flowing
water into the container you have
placed in front of the filter. Always
keep a piece of cloth handy to absorb
any spilled water.
c
When the water inside the product is
finished, take out the filter completely
by turning it.
Washing Machine / User's Manual
Advertisement
Table of Contents
