Removing The Transportation Locks; Connecting Water Supply - Beko WMB 91242LB User Manual
Hide thumbs
Also See for WMB 91242LB:
Table of Contents
Advertisement
4.4.3 Removing the transportation locks
1
Loose all bolts with an appropriate wrench until they turn freely (C).
2
Remove the transport safety bolts by turning them slightly.
3
Insert the plastic covers in the bag containing the user manual to the openings on
the rear panel. (P)
A
CAUTION:
Otherwise, the product will be damaged.
C
Keep the transportation safety bolts in a safe place to reuse when the washing machine needs to
be moved again in the future.
Install the transport safety bolts in reverse order of the disassembly procedure.
Never move the product without the transportation safety bolts properly fixed in place!
4.4.4 Connecting water supply
C
The water supply pressure required to run the product is between 1 to 10 bars (0.1 – 1 MPa). It is
necessary to have 10 – 80 liters of water flowing from the fully open tap in one minute to have
your machine run smoothly. Attach a pressure reducing valve if water pressure is higher.
If you are going to use the double water-inlet product as a single (cold) water-inlet unit, you must
install the supplied stopper to the hot water valve before operating the product. (Applies for the
products supplied with a blind stopper group.)
A
CAUTION:
such a case the laundry will get damaged or the product will switch to protection mode and will
not operate.
CAUTION:
your laundry.
Connect the special water supply hoses supplied with the product to the
water inlets on the product. Red hose (left) (max. 90 ºC) is for hot water
inlet, blue hose (right) (max. 25 ºC) is for cold water inlet.
Make sure that the hot and cold water taps are connected correctly when
the product is being installed. Otherwise, your laundry will come out hot
at the end of the washing process and wear out.
13 / EN
Remove the transportation safety bolts before operating the washing machine!
Models with a single water inlet should not be connected to the hot water tap. In
Do not use old or used water inlet hoses on the new product. It may cause stains on
Washing Machine / User's Manual
Advertisement
Table of Contents
