Installation; Appropriate Installation Location; Removing Packaging Reinforcement - Beko WMB 91242LB User Manual

Hide thumbs Also See for WMB 91242LB:

Table of Contents

4.4 Installation

• Apply to the nearest authorized service agent for the installation of your product.

• Preparation of the location and electrical, tap water and waste water installations at

the place of installation is under customer's responsibility.

• Make sure that the water inlet and discharge hoses as well as the power cable are not

folded, pinched or crushed while pushing the product into its place after installation or

cleaning procedures.

• Make sure that the installation and electrical connections of the product are

performed by authorized service. Manufacturer shall not be held liable for damages

that may arise from procedures carried out by unauthorized persons.

• Prior to installation, visually check if the product has any defects on it. If so, do not

have it installed. Damaged products cause risks for your safety.

• Place the product on a hard and level floor. Do not put it onto a carpet with high pile or

other similar surfaces.

• When the washing machine and drier are placed on top of each other, their total

weight –when loaded– amounts to 180 kilograms. Place the product on a solid and flat

floor that has sufficient load carrying capacity!

• Do not place the product on the power cable.

• Do not install the product in the environments where the temperature falls below 0 ºC.

• Leave a minimum space of 1 cm between the machine and the furniture.

• On a graduated floor, do not place the product next to the edge or on a platform.

12 / EN

Tilt the machine backwards to remove the packaging

reinforcement. Remove the packaging reinforcement by

pulling the ribbon. Do not make this operation alone by

yourself.

Washing Machine / User's Manual

Table of Contents

Wmb 91242lc