Related Manuals for Philio PAN03-1B
Summary of Contents for Philio PAN03-1B
- Page 1 PAN03-1B/-2B/-3B PAN10-1B/-2B/-3B Switch Module with meter Fig 2. PAN10 Assembling Fig 1. PAN03 Assembling...
- Page 2 function, and to include/exclude/associate devices Annotation This plug-in ON/OFF switch PAN03/PAN10 is a security enabled wireless switch, Function Description based on Z-Wave Plus technology. Z-Wave Plus enabled devices displaying the No node ID The Z-Wave Controller does not allocate 2-second on, 2-second off Z-Wave Plus logo can also be used with it regardless of the manufacturer, and can a node ID to the Switch.
-
Page 3: Led Indication
Installation Failed or success in including/excluding the node ID can be viewed from the Z-Wave Controller. 1. Put the in wall switch into a wall box and connect the AC power wire L,N to PAN03/PAN10 connector L, N. Sometimes people are not easy to execute exclusion or inclusion especially when PAN03 already installed in a wall box. - Page 4 Meter Report Command: [Command Class Basic, Basic Set, Value = 1~99,255(0xFF)]: the load [Command Class Meter，Meter Report，Rate Type = 0x01，Meter Type = attached to the Switch turns on. 0x01，Precision = 1，Scale = 0x02，Size = 4，Meter Value(W) ] [Command Class Basic, Basic Set, Value = 0(0x00)]: the load attached to the Switch turns off.
- Page 5 Size = 2 (2 Bytes of V) Meter Value 1 = 0x09(V) Meter Get Command: [Command Class Meter, Meter Get, Scale = 0x00 KW/h)] Meter Value 2 = 0x01(V) Meter Report Command: AC load Voltage = (Meter Value 1*256) +(Meter Value 2)= 230.5 (V) [Command Class Meter，Meter Report，Rate Type = 0x01，...
- Page 6 3. Z-Wave’s Configuration 3-2 KWH Meter Report Period: If the setting is configured for 1hour (set value =6), the PAN03/PAN10 will report its Accumulated Power Consumption (KW/h) every 1 hour to Group1 node. The Configuration Function Size Value Unit Default Description maximum interval to report its Accumulated Power Consumption (KW/h) is 227.55 Parameter...
-
Page 7: Troubleshooting
Whenever a switch off command, BASIC_SET 、 BINARY_SWITCH_SET 、 PAN11 is based on 500 series SoC and supports Firmware Update Command Class, SWITCH_ALL_OFF, is received, it could be interpreted as 4 variety of commands. it can receives the updated firmware image sent by controller via the Z-wave RF 3-9-1 Switch Off：It switches to OFF state. -
Page 8: Specification
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. Company of License Holder：Philio Technology Corporation This transmitter must not be co-located or operating in conjunction with any other antenna or Address of License Holder：8F.,No.653-2,Zhongzheng Rd., Xinzhuang Dist., New...
Need help?
Do you have a question about the PAN03-1B and is the answer not in the manual?
Questions and answers