Silvercrest SV 120 A1 Operating Instructions Manual page 66

NOTE
► The bag opening must lie flat on the welding wire 4 . Otherwise the weld-
ing does not work properly .
4) Close the appliance lid 1 . The press seal q presses the bag onto the welding
wire 4, to create a smooth seam . Ensure that both corners of the appliance
lid 1 click closed . If necessary, press them down once again on the markings
and
5) Press the
sealing process is finished, the red control lamp w goes off .
NOTE
► You can halt the sealing process at any time by pressing the
again . The red control lamp goes out w .
CAUTION – PROPERTY DAMAGE!
If the red control lamp w does not go out after a maximum of
10 seconds, there is a fault with the appliance .
► Remove the plug from the mains power socket immediately . Do not attempt
to repair the appliance yourself . Contact the Customer Service department .
6) Open the appliance lid 1 by pressing the lid release 8 and flipping the lid 1
upwards . Remove the bag . This is now sealed at one end .
NOTE
► Ensure that the weld seam is properly closed . A correct weld seam should
be a smooth, straight stripe without any creases .
7) Fill the bag . You must leave at least 6 cm of the bag free up to the edge to
be welded .
CAUTION – PROPERTY DAMAGE!
► Fill the bag so that no food scraps or liquids can leak out during welding
and get into the appliance .
8) If you do not want to vacuum the bag, you can now weld the other, open side .
NOTE
► Wait 15 seconds before sealing the next bag to allow the appliance to
cool down .
During this cool-down phase, you cannot start the "seal" function .
SV 120 A1
so that the appliance lid 1 clicks into place and locks shut .
button r . The red control lamp w lights up . As soon as the
button r
GB │ MT │ 63 ■