Installing The Weight - Toro TimeCutter 79335 Operator's Manual

1

Installing the Weight

Parts needed for this procedure:
4 Bolt (3/8 x 1-1/4 inches)
4 Lock nut (3/8 inch)
1 Weight mounting bracket, left
1 Weight mounting bracket, right
4 Washers
1 Weight holding bracket
2 Bolt (3/8 x 1 inch)
1 Flat weight
1 Suitcase weight
1 Keyed cross bar
Procedure
CAUTION
The bagger changes the weight distribution of the
machine. Operating the machine without the front
weights may cause an unstable condition which
could result in a loss of control.
Ensure the front weights are properly installed
before operating the machine with the bagger
attachment.
1. Locate the forward bolts on the underside of the frame
(Figure 3 and Figure 4). Remove the two bolts (3/8 x 1
inch) and two locknuts (3/8 inch). Retain the lock nuts.
1
1. Front right caster (castor
fork and wheel not shown
for clarity)
2. Forward hole, right side
1
1. Locknut (3/8 inch)
2. Forward hole, left side
2. Locate the left and right weight mounting brackets in
loose parts. Start by installing the left bracket to the
under side of the frame.
3. Secure the bracket to the frame using two bolts (3/8
x 1-1/4 inches), two washers and two lock nuts (3/8
inch) (Figure 5). One locknut is from loose parts and
the other is reused from earlier removal.
6
2
3
4
Figure 3
3. Bolt (3/8 x 1 inch)
4. Locknut (3/8 inch)
3
2
G014877
4
Figure 4
3. Front left caster (castor
fork and wheel not shown
for clarity)
4. Bolt (3/8 x 1 inch)
G014875