Table of Contents
Advertisement
Removing the Bagger
CAUTION
Failing to remove the front bagger weights
and operating the machine without the bagger
attachment may cause an unstable condition which
could result in a loss of control.
• Always remove the front weights when removing
the bagger attachment.
• Never operate the machine without the bagger
attachment and the front weights still installed.
The bagger can be removed by repeating the Setup sections
from all installed bagger related kits in reverse order. If
weights are installed, always remove the front bagger weights
when removing the bagger attachments.
Note: It is only necessary to remove the cutoff baffle when
installing a mulching kit.
Using the Draw Bar
The bagger support bracket has a draw bar feature that can
be used for towing.
•
Read and understand all the operating instructions of the
machine.
•
When turning, slow down and observe the clearance.
•
Make wide turns and keep towed equipment clear of the
towing vehicle.
•
The maximum draw bar pull is 80 lb (36 Kg).
•
Excessive draw bar pull may cause hydrostatic
transmission failure.
g020319
1. Bagger support bracket with draw bar
1
Figure 28
Operating Tips
Tips for Bagging
Size
Remember that the mower is longer and wider with this
attachment installed. By turning too sharply in confined
places you may damage the attachment.
Trimming
Always trim with the left side of the mower. Do not trim
with the right side of the mower because you could damage
the bagger's chute and discharge tube.
Cutting Height
Do not set the mower cutting height too low because long
grass surrounding the mower can prevent air from getting
under the mower and entering the bagging system. If enough
air doesn't get under the mower, the bagging system will plug.
Cutting Frequency
Cut the grass often, especially when it grows rapidly. You will
have to cut your grass twice if it gets excessively long.
Cutting Technique
For best lawn appearance, be sure to slightly overlap the
mower into the previously cut area. This helps reduce the
load on the engine and reduces the chance of plugging the
chute and discharge tube.
Bagging Speed
Most often you will bag with the mower throttle in the Fast
position and drive at a normal ground speed. However,
in extremely dry and dusty grass, you may want to slightly
reduce the throttle speed and increase the ground speed
of the mower. The bagging system may plug if you drive
too fast and the engine speed gets too slow. On hills it may
be necessary to slow the mower ground speed. This helps
maintain the engine speed and bagging efficiency. Mow
downhill whenever possible.
15
Advertisement
Table of Contents
