Installing The Rear Weight - Toro Groundsmaster 200 Series Operator's Manual

33. Install the remaining hose to the 90 fitting on the
bottom of the manifold block and the remaining
opening on the cross fitting with 2 hose clamps.
Reposition the 90 fitting, as required, for the hose
connection.
34. Replenish the oil in the transmission, as required.
1
3
Figure 14
1. Cross fitting
2. Right lift cylinder hose
2
1
3
4
Figure 15
1. Cross fitting (92-5640)
2. Right lift cylinder hose
3. Left lift cylinder hose
2
4
3. Left lift cylinder hose
4. Return hose
5
6
4. Return hose
5. Hose to manifold block
6. Hose to manifold block
14
Note: The test port is used to check the hydraulic circuit
pressure. Check the pressure with the lift lever in the Float
position, the engine running at high idle, and the hydraulic
oil at its normal operating temperature (Fig. 16). Contact
your local Toro distributor for assistance.
Normal counterbalance setting is 100 psi (689 kPa).
1
Figure 16
1. Adjusting screw
Note: The counterbalance has been preset at the factory and
should not require adjusting. Rotating the manifold screw
to increase or decrease pressure will increase or decrease
the counterbalance (Fig. 16).

Installing the Rear Weight

Two Wheel Drive Groundsmaster 1000 and 200 Series
traction units comply with the ANSI B71.4-1999 Standard
when equipped with rear weight. Refer to the chart in the
traction unit Operator's Manual to determine the
combinations of weight required. Order the parts from your
local Authorized Toro Distributor.
Four Wheel Drive Groundsmaster 200 Series traction units
do not need additional rear weight to comply with the
ANSI B71.4-1999 Standard.
2
2. Test port