Toro TimeCutter 79335 Operator's Manual page 7

2
1
G014878
8
Figure 5
1. Locknut (3/8 inch), existing 5. Hole, existing in frame
2. Forward hole, left side
3. Front left caster (castor
fork and wheel not shown
for clarity)
4. Locknut (3/8 inch), loose
parts
4. On the right side of the machine install the right weight
mounting bracket.
•
For machines without a foot assist lift pedal: secure
the bracket using two bolts (3/8 x 1-1/4 inches),
two washers and two lock nuts (3/8 inch) (Figure
6). One locknut is from loose parts and the other
is reused from earlier removal.
1
8
7
6
G014876
Figure 6
1. Front right caster (castor
fork and wheel not shown
for clarity)
2. Forward hole, right side
3. Locknut (3/8 inch), existing 7. Hole, existing in frame
4. Right mounting bracket
•
For machines with a foot assist lift pedal: The
washers will not be needed. Instead, remove
3
4
5
7
6. Washer
7. Bolt (3/8 x 1-1/4 inches)
8. Left mounting bracket
2
3
4
5
5. Bolt (3/8 x 1-1/4 inches)
6. Washer
8. Locknut (3/8 inch), loose
parts
the forward fasteners in the foot assist lift pedal
bracket. Secure the bracket using two bolts and
two lock nuts (Figure 7). One locknut is from loose
parts and the other is reused from earlier removal.
6
7
6
G014883
1. Front right caster (castor
fork and wheel not shown
for clarity)
2. Forward hole, right side
3. Locknut (3/8 inch), existing 7. Hole, existing in bracket
4. Right mounting bracket
5. Install the weight holding bracket to the mounting
brackets (Figure 8). Align the outboard holes in the
bracket with the mounting brackets installed previously.
Make sure the bracket is centered on the frame. Secure
with two bolts (3/8 x 1 inch) and two lock nuts (3/8
inch).
1. Locknut (3/8 inch)
2. Weight holding bracket
3. Left mounting bracket
7
2
1
8
5
Figure 7
5. Bolt (3/8 x 1-1/4 inches)
6. Foot assist lift pedal
bracket
8. Locknut (3/8 inch), loose
parts
1
G014879
5
Figure 8
4. Bolt (3/8 x 1 inch)
5. Right mounting bracket
3
4
2
3
4