Toro TimeCutter 79335 Operator's Manual page 9

3
Installing the Bagger Frame
Parts needed for this procedure:
1 Bagger frame support bracket
1 Support spacer plate
2 Self tapping screw (5/16 x 3/4 inch)
2
Bolt (5/16 x 1 inch)
4 Lock nut (5/16 inch)
1 Angled bracket
2 Carriage bolt (5/16 x 3/4 inch)
1 Bagger frame
1 Clevis pin (1/2 x 2-1/4 inch)
5 Hair pin cotter
2 Rod
4 Washer
Procedure
1. Locate the bagger frame support spacer plate and
bracket in loose parts. Install the plate and support
bracket to the machine frame as shown in Figure 11.
Secure the support plate and support bracket to the
frame using two bolts (5/16 x 1 inch) and two lock
nuts (5/16 inch).
G014881
6
1. Machine frame
2. Support spacer plate
3. Support bracket
2. Secure the support bracket to the bottom of the
machine frame from below using two self tapping
screws (5/16 x 3/4 inch) as shown in Figure 12.
1
3
2
5
Figure 11
4. Bolt (5/16 x 2-1/2 inch)
5. Draw bar hole
6. Lock nut (5/16 inch)
G010578
1. Support bracket
3. Install the angled bagger bracket to the engine guard
using two carriage bolts (5/16 x 3/4 inch) and two
locknuts (5/16 inch).
G014882
1. Carriage bolt (5/16 x 3/4
inch)
2. Angled bracket
4
4. Install the bagger frame to the support bracket. Secure
the bagger frame with a clevis pin (1/2 x 2-1/4 inch)
and hair pin cotter (Figure 13).
9
2
Figure 12
2. Self tapping screws (5/16
x 3/4 inch)
1
2
4
Figure 13
3. Lock nut (5/16 inch)
4. Hole in engine guard,
existing
1
3