Brother HL-B2180DW Online User's Manual page 72

1. Press a or b to select the [Network] option, and then press OK.
2. Press a or b to select the [WLAN(Wi-Fi)] option, and then press OK.
3. Press a or b to select the [WPS/PIN Code] option, and then press OK.
4. When [WLAN Enable?] appears, select On.
This will start the wireless setup wizard.
5. The LCD displays an eight-digit PIN and the machine starts searching for a wireless LAN access point/router.
6. Using a computer connected to the network, in your browser's address bar, type the IP address of the device
you are using as the Registrar (for example: http://192.168.1.2).
7. Go to the WPS settings page and type the PIN, and then follow the on-screen instructions.
• The Registrar is usually the wireless LAN access point/router.
• The settings page may differ depending on the brand of wireless LAN access point/router. For more
information, see the instructions supplied with your wireless LAN access point/router.
If you are using a Windows 10 or Windows 11 computer as a Registrar, complete the following steps:
8. Hold down the
9. Type "control printers" in the Open: field and click OK.
The Devices and Printers window appears.
If the Devices and Printers window does not appear, click View more devices > More devices and
printer settings.
10. Click Add a device.
• To use a Windows 10 or Windows 11 computer as a Registrar, you must register it to your network in
advance. For more information, see the instructions supplied with your wireless LAN access point/
router.
• If you use Windows 10 or Windows 11 as a Registrar, you can install the printer driver after the wireless
configuration by following the on-screen instructions. To install the driver and software necessary to use
your machine, go to your model's Downloads page at support.brother.com/downloads.
11. Select your machine and click Next.
12. Type the PIN displayed on the machine's LCD, and then click Next.
13. Click Close.
If your wireless device is connected successfully, the machine's LCD displays [Connected].
You have completed the wireless network setup. To install the drivers and software necessary to use your
machine, go to your model's Downloads page at support.brother.com/downloads.
Related Information
• Use the Wireless Network
key and press the key on the computer's keyboard to launch Run.
67