Brother HL-B2180DW Online User's Manual page 151

Error Message
No Paper T1
No Toner
Out of Memory
Replace Drum
Replace Toner
Self-Diagnostic
Size Error
Size Error DX
Size Mismatch
Toner Low
Related Information
• Troubleshooting
Cause
The machine cannot feed paper
from the indicated paper tray.
The toner cartridge or the toner
cartridge and drum unit assembly
is not installed correctly.
The machine's memory is full.
It is time to replace the drum unit.
If this message appears after
replacing the drum unit, the drum
unit counter has not been reset.
The toner cartridge is at the end of
its life.
The fuser unit does not work
correctly.
The fuser unit is too hot.
The paper tray you selected does
not support the paper size
specified in the printer driver.
The paper size specified in the
machine's paper size setting is not
suitable for automatic 2-sided
printing.
The paper in the tray is not the
correct size and is not suitable for
automatic 2-sided printing.
The paper in the tray is not the
correct size.
If the LCD displays this message,
you can still print. The toner
cartridge is near the end of its life.
Action
Do one of the following:
• Refill paper in the paper tray indicated on
the LCD. Make sure the paper guides are
set to the correct size.
• If paper is in the tray, remove it and load it
again. Make sure the paper guides are set
to the correct size.
• Do not overfill the paper tray.
Remove the toner cartridge and drum unit
assembly. Remove the toner cartridge from the
drum unit, and reinstall the toner cartridge
back in the drum unit.
Reinstall the toner cartridge and drum unit
assembly back in the machine. If the problem
continues, replace the toner cartridge with a
new one.
See Related Information: Replace the Toner
Cartridge.
Press and hold Go for about two seconds and
reduce the print resolution.
Replace the drum unit with a new one.
See Related Information: Replace the Drum
Unit.
Reset the drum unit counter.
See Related Information: Reset the Drum
Counter.
Replace the toner cartridge with a new one.
See Related Information: Replace the Toner
Cartridge.
Press and hold to turn the machine off,
wait a few seconds, and then turn it on again.
Leave the machine idle for 15 minutes with the
power on.
Change the printer driver setting or the
machine's tray setting so that the paper size
selected in the printer driver matches the
paper size loaded in the tray you selected.
Load the correct size of paper in the tray and
set the tray for that paper size.
Choose a paper size suitable for 2-sided
printing. Press Go.
The paper size suitable for automatic 2-sided
printing is A4.
Load the correct size of paper in the tray
indicated on the LCD and set the size of paper
for the tray. Press Go.
Order a new toner cartridge now so you have
it ready when the LCD displays Replace
Toner.
146