True PERFORMANCE 1000 Owner's Manual page 24

STEP 7—ATTACH CONSOLE, CONNECT POWER CORD, AND CALIBRATE
Tools Used in this Step
#2 Phillips Screwdriver
1. Using a #2 Phillips screwdriver, secure the console to the console mast using the hardware preassembled to the
console (00567800 // SCREW, M5-.8X12 COMBO PHILLIPS/COMMON TRUSS HEAD - ACG BLACK // QTY 4).
NOTE: If the console also has three screws (00567700 // SCREW, M4-.7 X 12 PPHMS SEMS // QTY 3)
preassembled, remove and set aside these screws. They are not used in this installation.
NOTE: Loosen but do not remove the bottom two preassembled screws (00567800), those slide into the keyhole slots
on the console mast.
2. Connect the console cables and ensure all cables are routed inside the console mast to avoid pinching the cables.
IMPORTANT! Please see the console owner's manual for more detailed information on the console cable
connections, machine setup, and use.
3. Connect the power cord into the power inlet and then power on the treadmill.
4. Follow the instructions in the console owner's manual to verify the correct base is confi gured to the console, and then
calibrate the machine.
24
00567800
remove and
set aside these
screws, they are
not used in this
installation
00567700
Parts Used in this Step
Part Description
PS0036A POWER CORD, RIGHT ANGLE, PS 300CM
Console
Console
Mast
Qty
1
PS0036A
ON
OFF