True PERFORMANCE 1000 Owner's Manual page 19

STEP 3—ROUTE AND CONNECT LOWER CABLES—INSTALL OPTIONAL
AUXILIARY POWER SUPPLY (IF NEEDED*)
Tools Used in this Step
7/16" Wrench
Wire Cutters*
*NOTE: Certain touch screen and PVS consoles require the optional auxiliary power supply.
Carefully make the following cable connections between the pedestals and the base:
• I/O Communication Cable to the Lower Control Board
• Coaxial Cable to the Base
NOTE: Carefully route the coaxial cable underneath the incline motor mounting bracket to avoid damage to the cable.
NOTE: To fully tighten the coaxial cable nut, use a 7/16" wrench.
• Power AUXPS Cable Connections
NOTE: If an auxiliary power supply is not being used, connect the DC plug and DC jack and tuck out the way to avoid
damage to the cables.
NOTE: If an auxiliary power supply is being used, make the DC power connection to the auxiliary power supply and
then secure the cables and power suppy with zip ties. See page 20 for more information.
coaxial cable
coaxial cable not
installed
Parts Used in this Step
PART
00595500*
TC6085_005* ZIP TIE
!
CAUTION: AVOID DAMAGE!
ROUTE CABLE UNDER THE INCLINE
incline
MOUNTING BRACKET—ALWAYS KEEP
motor
CABLES AWAY FROM MOVING PARTS!
mounting
bracket
route coaxial remove the nut
cable underneath and washer from
the incline motor the end of the
mounting bracket coaxial cable
DESCRIPTION
FUYANG POWER SUPPLY 12V 6AMP
lower
control
DC jack
board
DC plug
I/O cable
insert the coaxial cable coaxial cable
through the opening installed
on the frame and use
the washer and nut to
secure in place
QTY
1
3
19