2.3
Assembly
Before assembly, take a close look at the individual assembly steps shown and carry out the assembly
in the order given.
NOTICE
L
First loosely screw all parts together and check that they fit properly. Tighten the screws using
the tool only when you are instructed to do so.
Step 1:
Assembly of the Upright Supports and Joint Tubes, part 1
1.
Slide on two oval end caps (8) on the feet of the upright support (1).
2.
Mount the left joint tube (3) along with one reinforcement plate (5) to the upright support (1)
with two screws (11), four washers (12) and two locknuts (13).
11
12
12
12
13
Barbell Rack