Table of Contents
Advertisement
Placing Unit at Location
1.
Carry the unit to the installation location
2.
Reassembly by reversing the steps listed in Section 4 if
disassembly was required. If cut, wire ties that held the sensor
wiring must be replaced.
Important: Under no conditions should metal strapping be attached
to the unit to be used as support mechanisms for carrying
or suspension purposes.
Approved Carrying:
•
Hold by the cross members within the cabinet or unit top plate and
use as handles for lifting and carrying the coil and blower sections.
18-GJ89D1-1F-EN
13
Advertisement
Table of Contents
Troubleshooting
