Table of Contents
Advertisement
Finishing
As soon as the cleaning aid has finished, an audible
signal sounds and the appliance ends the operation
automatically.
As soon as you open the appliance door, the interior
lighting is switched on so that you can finish cleaning
the cooking compartment more easily. The remaining
water in the cooking compartment must be removed
promptly. Do not leave the remaining water in the
cooking compartment for a long time (e.g. overnight).
The appliance must not be operated when the cooking
compartment is still wet or damp.
Final cleaning
Open the appliance door and remove the remaining
1.
water with an absorbent sponge cloth.
Clean the smooth surfaces in the cooking
2.
compartment with a dish cloth or a soft brush.
Stubborn residues can be removed using a stainless
steel scouring pad.
Remove limescale with a cloth soaked in vinegar.
3.
Then wipe with clean water and rub dry with a soft
cloth (including under the door seal).
Use the # touch button to switch off the appliance.
4.
Leave the appliance door ajar in the locking position
5.
(approx. 30°) for approx. 1 hour to allow the enamel
surfaces in the cooking compartment to dry.
Alternatively, you can also run the rapid drying
function for the cooking compartment.
Running the rapid drying function for the cooking
compartment
After the cleaning aid process has finished, leave the
1.
appliance door ajar in the locking position (approx.
30°).
Touch the # touch button.
2.
Start CircoTherm hot air at 50 °C.
3.
After 5 minutes, switch off the appliance and close
4.
the appliance door.
Removing heavy deposits of dirt
You have several options for removing particularly
stubborn deposits of dirt.
Leave the soapy water to work for some time before
■
starting the cleaning aid.
Rub soapy water onto the dirt on the smooth
■
surfaces before starting the cleaning aid.
Repeat the cleaning aid once the cooking
■
compartment has cooled down.
pRails
W ith good care and cleaning, your appliance will retain
R a i l s
its appearance and remain fully functional for a long
time to come. This will tell you how to remove the
shelves and clean them.
Changing the shelf position for the
telescopic rail
Bars and telescopic rails can be positioned in any
order. For example, you can fit the telescopic rail to the
shelf position which you use the most frequently.
Removing the bar
Telescopic rails are removed and fitted like bars.
Push the bar towards the back ‚ until it can be
1.
pulled out upwards ƒ (Fig.
Unhook the bar at the back and remove it (Fig.
2.
Fitting the bar
Fit the bar at the back (Fig.
1.
en
Rails
!
).
"
).
!
).
23
Advertisement
Table of Contents
