Table of Contents
Advertisement
Remove limescale marks with a cloth soaked in vin-
3.
egar, then wipe with clean water and dry with a soft
cloth.
Leave the cooking compartment to dry with the ap-
4.
pliance door open for 1 hour or use "Drying func-
tion".
→ "Setting 'Drying function'", Page 31
22.2 Setting "Drying function"
Requirement: → "Drying the cooking compartment",
Page 30
Press "Cleaning".
1.
Rails
23 Rails
To thoroughly clean the rails and the cooking compart-
ment, or to replace the rails, you can remove the rails.
23.1 Detaching the rails
WARNING ‒ Risk of burns!
The shelf supports get very hot
Never touch the shelf supports when hot.
▶
Always allow the appliance to cool down.
▶
Keep children at a safe distance.
▶
Lift the rail forwards slightly
1.
Pull the whole rail to the front
2.
Clean the rail.
3.
→ "Cleaning products", Page 26
Appliance door
24 Appliance door
To clean the appliance door thoroughly, you can disas-
semble the appliance door.
WARNING ‒ Risk of injury!
If the hinges are not secured due to an incomplete
lock, they can snap shut with great force.
To detach or attach the appliance door, always turn
▶
the two locks as far as they will go.
If the hinge snaps closed when detaching or attach-
▶
ing the appliance door, do not reach into the hinge
– call the after-sales service.
and detach it
.
and remove it.
Press "Drying function".
2.
a The duration appears on the display. You cannot
change the duration of the drying function.
Start the drying function using
3.
a A notification stating that you should carry out the
necessary preparatory work for the drying function
appears on the display.
Press "OK" to confirm the notification.
4.
a The drying function starts. The duration counts down
on the display.
a Once the drying function has run through to the
end, an audible signal sounds.
Leave the appliance door open for 1-2 minutes so
5.
that the cooking compartment dries completely.
23.2 Attaching the rails
Notes
¡ The rails only fit on the right or left.
¡ For both rails, ensure that the curved rods are at the
front.
First, push the rail into the middle of the rear
1.
socket
until the rail rests against the cooking
compartment wall, and then push this back
Push the rail into the front socket
2.
also rests against the cooking compartment wall,
and then press this downwards
Note:
Further information:
Rails en
.
.
until the rail
.
31
Advertisement
Table of Contents
