Detaching And Refitting The Rails; Appliance Door; Removing And Fitting The Appliance Door - NEFF B47CS34 0 Series Instruction Manual

Table of Contents

Advertisement

en

Appliance door

Push the bar towards the back ‚ and down ƒ onto
2.
the pin „ (Fig.
"
).
Ensure that the hook is hooked onto the pin „ (Fig.
3.
#
).

Detaching and refitting the rails

:
Warning – Risk of burns!
The rails become very hot. Never touch the hot rails.
Always allow the appliance to cool down. Keep children
away from the appliance.
Detaching the rails
Lift the rail slightly at the front ‚ and detach it ƒ (do
1.
not hold by the accessory holders or the telescopic
shelf) (figure
!
).
Then pull the whole rail towards you and take it out
2.
(figure
"
).
Clean the rails with cleaning agent and a sponge. For
stubborn deposits of dirt, use a brush.
Attaching the rails
The rails only fit on the right or the left side. The pull-out
rails must pull out towards you.
First, insert the rail in the middle of the rear socket ‚,
1.
until the rail rests against the cooking compartment
wall, and push it back ƒ (figure
Then insert the rail into the front socket „, until the
2.
rail also rests against the cooking compartment wall
here, and press it downwards ... (figure
24
!
).
"
).
qAppliance door
W ith good care and cleaning, your appliance will retain
A p p l i a n c e d o o r
its appearance and remain fully functional for a long
time to come. This will tell you how to remove the
appliance door and clean it.

Removing and fitting the appliance door

To clean the door panels, you can detach the appliance
door.
:
Warning – Risk of injury!
The hinges of the appliance door may snap shut with
great force. Always fully turn the two locks for fitting and
removing the appliance door.
:
Warning – Risk of injury!
If the appliance door has been removed without turning
both locking levers to their limit stops, the hinge may
snap shut. Do not reach into the hinge. Call the after­
sales service.
Detaching the appliance door
Open the left- and right-hand door locks (fig.
1.
To do this, hold the screwdriver horizontally and use
it to push the door lock (black component) on each
side of the door all the way up (fig.
Tip: Use a torch to light up the gap so that you can
see the door locks.
Door lock closed (fig.
Door lock open (fig.
"
).
#
)
$
)
!
).

Advertisement

Table of Contents
loading

Table of Contents