Table of Contents
Advertisement
22.2 Attaching the rails
Notes
¡ The rails only fit on the right or left.
¡ For both rails, ensure that the curved rods are at the
front.
First, push the rail into the middle of the rear
1.
socket
until the rail rests against the cooking
compartment wall, and then push this back
Push the rail into the front socket
2.
also rests against the cooking compartment wall,
and then press this downwards
22.3 Removing the pull-out rail
WARNING ‒ Risk of burns!
The shelf supports get very hot
Never touch the shelf supports when hot.
▶
Always allow the appliance to cool down.
▶
Keep children at a safe distance.
▶
ATTENTION!
The self-cleaning surfaces in the cooking compartment
may be damaged by detaching and attaching the pull-
out rails.
Detach the rails before detaching or attaching the
▶
pull-out rails.
Notes
¡ Depending on the appliance type, you must change
the basic settings for the telescopic rails for appli-
ances with rails and pull-out rails.
→ "Basic settings", Page 25
¡ The pull-out rails can be installed at any level as re-
quired.
¡ If necessary, you can equip all levels with a pull-out
rail.
Push on the side of the tab marked PUSH behind
1.
the rail, and push the rail to the rear.
.
until the rail
.
Press and hold PUSH
2.
wards
until the front retainer
a
Pull the rail out towards the front.
3.
Remove the pull-out rail.
4.
Clean the pull-out rail.
5.
→ "Cleaning products", Page 28
Note:
Further information:
22.4 Attaching the pull-out rail
Note: The pull-out rails only fit on the right or left. Make
sure when you fit them that you can pull them out to-
wards the front.
Rails en
and swing the rail out-
is detached.
33
Advertisement
Table of Contents
