Advertisement
Screen Adjustment: Screen can be adjusted horizontally by loosening safety/security screws on tilt brackets (AA & BB)
three full turns. Adjust screen as shown in figure 2.2. Tighten safety/security screws on tilt brackets using 4 mm allen
wrench (CC) till screw tip securely contacts wall plate as shown in cross section.
Removing Screen: To remove screen from mount, loosen safety screws, swing screen away from mount, and lift screen
off of mount.
Adjusting the Tilt Angle of the Flat Panel
Screen
For preset tilt angles use Increlok™ and for
3
custom tilt angle use ratchet handle.
INCReLoK™: The screen can be locked into a
pre-set tilt position of -5°, 0°, 5°, 10° or 15°. Use
locator hole to find tilt position hole and tilt screen
to align holes. Tighten Increlok™ tilt locking
screws on both tilt brackets to lock tilt as shown in
detail 2.
Ratchet Handle: loosen ratchet handle (refer
to step 3 for tension adjustment of handle). Push
or pull from top or bottom of screen to adjust tilt
as shown in fig. 3.1. The tilt can be adjusted to a
maximum of 15° forward or 5° backward.
wALL PLATe MAy APPeAr
DIffereNT THAN ILLUSTrATeD
Increlok™
TIlT
LOCkINg
SCrew
TIlT
POSITION
HOlES
7 of 7
All other brand and product names are trademarks or registered trademarks of their respective owners.
fig 2.2
LOCATOr
HOlE
rATCHeT
HANDLe
DeTAIL 2
fig 3.1
ISSUED: 06-04-10 SHEET #: 120-9080-2 05-14-12
© 2010, Peerless Industries, Inc. All rights reserved.
Advertisement
