Page 1
S9 AutoSet indications for use The S9 AutoSet self-adjusting system is indicated for the treatment of obstructive sleep apnoea (OSA) in patients weighing more than 30 kg. The S9 AutoSet self-adjusting system is intended for home and hospital use. S9 Elite indications for use The S9 Elite CPAP system is indicated for the treatment of obstructive sleep apnoea (OSA) in patients weighing more than 30 kg.
Page 2
Troubleshooting If there is a problem, try the following suggestions. If the problem cannot be solved, contact your equipment supplier or ResMed. Do not attempt to open these devices. Problem/Possible cause Solution No display Power is not connected. Ensure the power cable is connected and the power outlet (if available) is on.
Page 3
Turn the humidifier setting down and empty the water accumulation of water in the air tubing. from the air tubing. Displays error message: Check ResMed 30/90W Power Supply Unit and fully insert the connector The DC plug is partially inserted into the Fully insert the DC plug.
Problem/Possible cause Solution Displays error message: High leak, please check system setup and all connections There is excessive leak. Adjust position of mask and headgear. Air tubing is not connected properly. Connect firmly at both ends. The following message is displayed on the LCD after you try to update settings or copy data to the SD card: Card error, please remove SD card and contact service provider SD card is not inserted correctly.
Page 5
90W power supply unit Input range 100–240V, 50–60Hz, Nominal for aircraft use 115V, 400Hz Typical power consumption 70W (80VA) Maximum power consumption 110W (120VA) 30W power supply unit Input range 100–240V, 50–60Hz, Nominal for aircraft use 115V, 400Hz Typical power consumption 20W (30VA) Maximum power consumption 36W (75VA) Operating temperature +5ºC to +35ºC...
Page 6
1 m away from the device. Information regarding the electromagnetic emissions and immunity of these ResMed devices can be found on www.resmed.com, on the Products page under Service and Support. Click on the PDF file for your language.
Page 7
If you need information on these disposal systems, please contact your local waste administration. The crossed-bin symbol invites you to use these disposal systems. If you require information on collection and disposal of your ResMed device please contact your ResMed office, local distributor or go to www.resmed.com/environment.
Page 8
• Portable diagnostic/screening devices This warranty is only available to the initial consumer. It is not transferable. If the product fails under conditions of normal use, ResMed will repair or replace, at its option, the defective product or any of its components.
Page 9
This warranty gives you specific legal rights, and you may also have other rights which vary from region to region. For further information on your warranty rights, contact your local ResMed dealer or ResMed office. WARNINGS • Read the entire manual before using the device.
Page 10
• Only use the ResMed 90W or 30W power supply unit. Use the 90W power supply unit to power the system comprising the device, H5i, air tubing, DC/DC converter and battery pack. The 30W power supply unit is designed to power the device only and recommended for traveling.
Page 11
See www.resmed.com for other ResMed locations worldwide. For patent information, see www.resmed.com/ip. S9, S9 AutoSet, S9 Elite, H5i, SlimLine, ClimateLine and SmartStart are trademarks of ResMed. S9, AutoSet, Slimline, ClimateLine and SmartStart are registered in U.S. Patient and Trademark Office.