Code Alarm PROFESSIONAL Series Installation Manual page 15

Feature Bank 3 - 5 Chirps
Output Control
1 Lock / Unlock Timing
2 Factory Disarm
3 Ignition Locks
4 Trunk Output Timing
5 Horn Output Timing
6 RPS - Real Panic Sound
Feature Bank 4 - 6 Chirps
Shock Sensor Adjustment
1 Full Trigger
2 Lite Touch
Feature Bank 4 - Shock Sensor Adjustment
1. Enter Feature Bank 4
2. Press and release
3. Use
each
4. Press
touch setting, the system will give 2 long chirps to confirm.
5. Use
6. Press and release
programming and give 1 long chirp to confirm. This step must be
completed to properly program the shock senor.
2020 Voxx Electronics Corporation. All rights reserved.
1 LED Flash
1 Sec.
N/A
OFF
N/A
N/A
ON
Press & Release Lock
Press Lock + Unlock for 2 seconds to lock in the change and move to next setting.
Press & Release Lock
Press and release Lock + Unlock to lock in the change and exit programming.
to select full trigger.
or to adjust the settings. The system will give short chirps upon
press.
+ for 2 seconds to lock in the change and advance to the lite
or to adjust the settings.
+
2 LED Flash 3 LED Flash
1 Sec. Lock,
3.5 Sec.
2x Unlock
Lock / Unlock Lock Only
OFF
Increase Sensitivity
to lock in the change, the system will exit
4 LED Flash 5 LED Flash
30 Sec. Lock, 2x Lock,
2x Unlock 1 Sec. Unlock
Unlock Only
Decrease Sensitivity
Press & Release Unlock
Press & Release Unlock
6 LED Flash
0.5 Sec.
15