Table of Contents
Advertisement
AS1011M-UR User's Manual
Support
The H8SMU supports single or dual-channel, DDR2-800/667/533 unbuffered ECC/
non-ECC SDRAM.
Both interleaved and non-interleaved memory are supported, so you may populate
any number of DIMM slots (see charts on following page).
Populating two slots at a time with memory modules of the same size and type will
result in interleaved (128-bit) memory, which is faster than non-interleaved (64-bit)
memory. See charts on following page.
Optimizing memory performance
For best results, populate slots in this order: 1A then 1B then 2A then 2B.
Maximum memory: 8 GB.
To Install: Insert module vertically
and press down until it snaps into
place. Pay attention to the bottom
notch.
To Remove: Use your thumbs
to gently push each release tab
outward to free the DIMM from the
slot.
Figure 5-3. Installing DIMM into Slot
5-8
DDR2 FBD DIMM
Top View of DDR2 FBD Slot
Advertisement
Table of Contents
