Table of Contents
Advertisement
Chapter 2: Server Installation
Installing the Server into a Telco Rack
To install the 1011M-UR into a Telco type rack, use two L-shaped brackets on ei-
ther side of the chassis (four total). First, determine how far follow the server will
extend out the front of the rack. Larger chassis should be positioned to balance
the weight between front and back. If a bezel is included on your server, remove
it. Then attach the two front brackets to each side of the chassis, then the two
rear brackets positioned with just enough space to accommodate the width of the
telco rack. Finish by sliding the chassis into the rack and tightening the brackets
to the rack.
Figure 2-4. Installing the Server into a Telco Rack
2-7
Advertisement
Table of Contents
