Safety Warning - ABB Protecta Power IV Assembly Manuallines

Safety
Warning
ALL PRODUCT(S) MUST BE INSTALLED BY A SUITABLY COMPETENT ELECTRICIAN CONSIDERING THEIR
INTENDED USE AND IN ACCORDANCE WITH THE CURRENT EDITION OF BS 7671 (IET WIRING REGULATIONS).
Notice:
To prevent potential overheating from loose connections the installer shall check connections are tightened
to the torque levels stated in these instructions prior to energising this board. This check should include
factory made connections which may have loosened in transit as shown below.
M8, T=10 Nm
M8, T=10 Nm
M10, T=20 Nm
M8, T=10 Nm
M8, T=10 Nm
M8, T=10 Nm
M10, T=20 Nm
For all shown screws please check the torque
 
2