Pairing And Unpairing The Rf Status Indicator; Pairing And Unpairing Rf Sensors - Heatrae Sadia Advance Plus Installation Manual

Hide thumbs Also See for Advance Plus:

Table of Contents

4.3. Pairing and unpairing the RF status

indicator control

For information about pairing and unpairing the RF status indicator

control, see the documentation included with that product.

4.4.1. Pairing RF sensors

Pair wireless sensors with the ventilation unit as follows:

a) Disconnect power to the ventilation unit.

b) Wait for at least 15 seconds.

c) Restore power to the ventilation unit.

d) Ensure that a pairing message is sent from the RF sensor within

two minutes after power to the ventilation unit is switched on.

For more information, consult the documentation for the

relevant sensor.

The RF sensor is paired, and the ventilation unit briefly changes the

motor speed to confirm the pairing. The ventilation unit is now

ready to respond to the signals of the wireless sensor.

4.4.2. Unpairing RF sensors

RF sensors can only be unpaired at the same time as an RF control

switch. For more information, see the procedure Unpairing RF

remote controls on page 25.

Note

If several RF controls and/or RF sensors are paired with the

ventilation unit, they must all be paired again after unpairing.

Table of Contents