Table of Contents
Advertisement
e) Now secure both wire brackets. First hook each bracket onto
the outside of the duct adapter using the holes intended for
this purpose, and then clip the underside of the bracket into the
underside of the housing of the ventilation unit. There is a
recess on the underside of the EPP housing into which the
bracket fits exactly.
2x
Note
The position of the ceiling bracket may need to be readjusted.
To do so, loosen the screws a little and shift the bracket in the
oversize holes.
2x
3.2.6. Floor mounting
ä
Caution!
With this mounting option, the ventilation unit needs to be
mounted with a tilt of at least 5° to ensure correct condensate
drainage. It is also important to ensure that the condensate
hose can be mounted with a slope from the ventilation unit to
the condensate drain.
a) Attach two wooden laths (50 x 100 x 600 mm and 50 x 50 x 600
mm, not provided) to the floor as shown in the diagram below.
50
b) Secure the mounting bracket to the higher of the two laths
using 6 mm screws (not provided).
c) Slip the duct adapters back over the mounting bracket and
push the two adapters to the left and to the right as far as they
will go.
50
580
21
Advertisement
Table of Contents
